Dust port is loose at the housing

The fixed dust port rocks or shifts relative to the tool housing when the connector is handled.

• Internal fastener or mount is loose
• Housing boss is cracked
• Hose side load damaged the port
• Impact stressed the port mount

1. The tool is not returned to use until the port is rigidly and safely restored.

1. Remove the battery and support the port while checking movement at the housing joint.
2. Remove the bag or hose and inspect for an open crack or exposed internal gap.
3. - Do not tighten through the housing or glue the port
4. Keep the tool out of dust-producing use and route it to authorized service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-30: Fm Dcw210 30

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.