Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

With the clamp lever working, a correct blade will not enter fully or fails the hand tug-check.
Clamp lever will not travel
The battery will not slide fully into the handle, stay retained, or release normally.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
With no fastener load, the bare or correctly fitted output sounds harsh, binds, knocks, or shakes abnormally.
The blade leaves the line, flexes excessively, bends, or breaks during an otherwise controlled cut.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The charger green LED does not flash, never becomes steady, or the battery remains discharged.
The forward/reverse button sticks, commands the wrong rotation, or center does not lock the trigger.
The motor runs normally, but the LED is dead, dim, or intermittent with trigger use.
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
The chuck, housing, handle, battery mount, labels, or vents are loose, cracked, obstructed, or damaged.
The drill stops early or gives far less runtime than expected without unusual heat.
THE BATTERY OR CHARGER WILL NOT BEGIN OR COMPLETE A CHARGE
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
The battery will not slide in, click into place, release, or remain secure in the handle.
The torque collar binds, will not stay on a setting, or the clutch slips or locks at every position.
The drill or battery becomes rapidly or severely hot, or little cooling air can move through the tool vents.
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.

Failure Modes

part