No response when the switch is set to I

With a battery installed and the switch at I, the sander gives no motor sound and the pad does not move.

• Main battery is discharged, damaged, or not latched
• Battery or tool contacts are dirty or damaged
• Switch is not fully at I
• Switch, control, terminal, or motor fault

1. The sander starts steadily at no load when the switch is set to I.

1. Set the switch to O, remove the pack, and prove a known-good charged battery.
2. Dry-brush both contact sets without bending or probing the terminals.
3. - Slide the known-good pack fully onto the rails until it latches
4. - Hold the tool clear of the work and select I

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-01: Fm Dcw210 01

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.